New Member
•
2 Messages
Internet dropping repeatedly all week – T3 time-outs, modem failing to register, heavy uncorrectable errors
Hi,
Can someone check my line and schedule a technician? My internet has dropped repeatedly all week. There are no reported outages, and rebooting doesn't help.
Setup: customer-owned Netgear CM400 modem (firmware V2.01.06), connected directly to an eero router. The coax runs into the wall of a condo building, so I have no splitters or connectors I can reach. The connector at the modem is tight.
What the modem log shows:
- Repeated "No Ranging Response received - T3 time-out". These have become more frequent: roughly monthly through the summer, about every 10 days since September, and several times this week.
- This week, after reboots, the modem several times failed to come back online:
"ToD request sent - No Response received"
"TFTP Request Retries exceeded, CM unable to register"
- "Lost MDD Timeout" at 20:28 tonight.
- Some "SYNC Timing Synchronization failure - Loss of Sync" earlier this year.
Signal levels tonight:
- Downstream (8 channels): power +9.0 to +10.0 dBmV, SNR 35.4–36.8 dB
- Upstream (4 channels): power 41.8–42.8 dBmV
- Uncorrectables: 550–760 per channel at 47 minutes of uptime, then 101,000–138,000 per channel at 69 minutes, spread evenly across all 8 channels. Correctables rose from near zero to about 25,000 per channel over the same period.
The even spread of uncorrectable errors across all channels looks like noise getting into the line. Since the cable runs inside the wall, I can't inspect it. Can you check my modem's signal history and nearby modems, and send a technician to check the line and the building's wiring?


Comcast_Shawn
Official Employee
•
22 Messages
16 hours ago
Click "Sign in" if necessary.
Click the "Direct Messaging" icon.
Click the "Start new conversion" (Pencil and paper) icon.
In the "To:" Line, type "Xfinity Support".
As you type, a drop-down list will appear. Select "Xfinity Support" from that list.
An "Xfinity Support" graphic will replace the "To:" line.
Type your message in the text area near the bottom of the window.
Press Enter to send it.
For an example on how to send us a Direct Message, check out this link: How to: Direct messaging within the forum | Xfinity Community Forum
1
0