Equipment (Modems,Gateways)
Modems, Gateways, and Networking Devices
Male IT Specialist Holds Laptop and Discusses Work with Female Server Technician. They're Standing in Data Center, Rack Server Cabinet is Open.
tdoris_protek
New Member

DPC3939B stopped doing 1-1 NAT on inbound static IPs

I've been running with the same config for months now, but after 2:00 am this morning inbound traffic is no longer being translated for the static IPs.  Instead of receiving traffic with the mapped 10.1.10.x LAN traffic I am instead getting traffic with the static IP.  I have verified 1-to-1 Network Address Translation is enabled as shown below Tried rebooting the DPC without effect.

 

 

 

1-to-1 NATa.png

 

0 Kudos
Reply
2 REPLIES 2
Community Manager
Community Manager

Re: DPC3939B stopped doing 1-1 NAT on inbound static IPs

Hello tdoris_protek,

 

I just refreshed the settings, are you still having any NAT issues? 

0 Kudos
Reply
kevinmcmurtrie
Frequent Contributor

Re: DPC3939B stopped doing 1-1 NAT on inbound static IPs

Can those LAN devices reach the Internet when 1:1 is turned on?  I had the same modem and it gradually stopped passing packets through any 1:1 NAT route.  Packet loss grew higher and higher until only a few packets per minute passed through.  A factory reset didn't fix it and no Comcast tech knew what 1:1 NAT is so the modem had to be replaced.

0 Kudos
Reply